HMC-230

Specified unit shall be FWE Model No. HMC-230, Heated Holding Cabinets.

CONSTRUCTION. Heliarc welded, single unit construction of stainless steel; 20 gauge polished exterior, 22 gauge stainless steel interior with easy-to-clean coved corners.

INSULATION. High density fiberglass insulation throughout; top, back, bottom, sides and door(s).

LEGS. Each leg shall be 4" have a reinforced mounting plate welded to base of unit.

SHELF. Triple-plated, welded rod-type shelf shall be removable. Shelf shall be supported by high-strength, "no sag" 14 gauge die-formed stainless steel brackets

DOORS AND HINGES . Flush mounted, seethru Lexan door shall include two (2) heavyduty hinges.

HEATED SYSTEM/CONTROLS. Long life Incoloy nickel-chromium alloy heating element; Hi-Temp, self-lubricated, impedance protected fan-cooled blower motor for heated air distribution. Rear mounted master ON/OFF power switch. Cabinet shall have a concealed full-range adjustable thermostat.

ELECTRICAL CHARACTERISTICS. 3 wire grounded tri-directional power cord and plug, rear mounted for safety. See electrical data chart above for amperage and receptacle configuration. See electrical data chart for models that may require a dedicated circuit.

INSTALLATION. Unit should not be installed in an area where adverse environmental conditions are present.

Provide with the following accessories: